Browsing by Subject "Titanium compounds"
Now showing items 1-9 of 9
-
Article
Comparative tribology studies of hard ceramic and composite metal-DLC coatings in sliding friction conditions
(1995)The design of anti-friction coatings able to perform well in different wear conditions without lubricants requires a combination of adequate hardness and toughness, good adhesion, a low friction coefficient and a low wear ...
-
Article
Correlation of elastic modulus, hardness and density for sputtered TiAlBN thin films
(2006)This paper describes the correlation between the elastic modulus, hardness and density of mainly X-ray amorphous TiAlxByNz (0.29 ≤ x ≤ 1.32
-
Article
Deposition and characterisation of TiAlBN coatings produced by direct electron-beam evaporation of Ti and Ti-Al-B-N material from a twin crucible source
(1999)TiAlBN coatings were synthesised by evaporating Ti and hot isostatically pressed TiAl0.68B3.67N2.44 material from a twin crucible source in an Ar plasma at 450°C. A combination of optical emission spectroscopy and partial ...
-
Article
Electron spectroscopic studies of nanocomposite PVD TiAlBN coatings
(2002)A range of TiAlBN coatings have been deposited by electron beam evaporation and the optimised composition exhibits a 150% improvement over single phase TiAlN coatings in drilling tests. The coatings have been analysed by ...
-
Article
Evaluating the microstructure and performance of nanocomposite PVD TiAlBN coatings
(2002)Physical vapour deposition (PVD) TiAlBN coatings can exhibit excellent wear resistance, with optimised coating compositions demonstrating a 150% increase in lifetime compared to standard TiAlN coatings in wet-cutting drill ...
-
Article
Nanostructural studies of PVD TiAlB coatings
(2006)TiAlB coatings with different compositions were deposited by co-sputtering from TiAl and TiB2 targets onto AISI316 stainless steel substrates at a temperature of 170 °C. The stoichiometry and nanostructure have been studied ...
-
Article
The selective oxidation of methane to C2-hydrocarbons over lithium-doped TiO2 catalysts
(1994)The oxidative coupling of methane (OCM) to C2-hydrocarbons was studied on a series of lithiumdoped titania catalysts by cofeeding methane (PCH4 = 0.5 bar) and oxygen (Po2 = 0.07-0.16 bar) at 1 bar total pressure in the ...
-
Article
Structure, mechanical and tribological properties of sputtered TiAlBN thin films
(1999)TiAlBN films were produced by simultaneously sputtering from TiAl and TiB2 targets in Ar/N2 mixtures at a substrate temperature of 150 °C. The goal of this investigation was to study the influence of the nitrogen content ...
-
Article
X-Ray diffraction investigations of magnetron sputtered TiCN coatings
(1995)X-ray diffraction measurements were performed on titanium carbonitride coatings produced in an electron enhanced, unbalanced magnetron system. The films were deposited onto AISI 316 stainless steel substrates with an argon ...